Aluminum Profile "PH" 6.5ft (78")

A slight design modification from our Aluminum Profile "P", "PH" features the same sleek and narrow look, but has a deeper, frosted lens which provides a more prominent lighting design. Aluminum Profile "PH" is designed to be suspended mounted, but can also be surface mounted. Create dot-free suspended LED lighting when paired with our high-density DOTLESS LED strips. Aluminum extrusion “PH” can accomodate any high-output LED strip up to 0.66" (16.7mm) wide and is designed to properly dissipate their heat. "PH" is conveniently sold in 6.5ft (78") lengths as a completed kit including a pair of end-caps, mounting clips, suspension kit and one frosted lens. View Spec Sheets Here!

Applications

Aluminum profile "PH" is designed to be suspended from the ceiling, but it can also be surface mounted by being screwed directly into your mounting surface. It's deep and narrow design make it an attractive solution for general and decorative lighting purposes in residential or commercial spaces. It is primarily designed for indoor use, but when paired with waterproof components, it can be used in outdoor applications.

Installation

With aluminum profile "PH", one has the option of using a suspension kit, or using mounting clips.

Maunting Methods

Mounting Method #1 (Use of Suspension Kit)

Install in minutes with our included suspension kit. Simply screw the anchor into your desired surface, install the included aircraft cable and cut to your desired length. Before Installing the closed end-cap onto light fixture, slide cable-grip retaining screws into the rear channel of the aluminum housing. Insert End-Cap, and tighten cable-gripper onto light fixture. Aircraft cable can now be pulled into the cable-grip and adjusted to desired suspension height.

Mounting Method #2 (Direct Screw to Surface Mounting)
Drill hole specific to your mounting screw diameter into aluminum housing. Counter-sink the hole so a flat-head screw can sit flush with the housing. Install LED Strip over screw.

Cutting

To cut your aluminum profiles and make your lighting fixtures a custom length, simply snap the lens onto the profile, and place the channel onto a miter saw with the lens facing down. By doing this you can easily cut both the channel and lens to your desired length at the same time. We recommend using a NEW fine tooth blade to cut your aluminum channels for LED strips. The diffuser/lens is fragile and will easily break with an old blade. The easiest way to avoid breaking a lens or diffuser is to lower the saw blade slowly while cutting.

DOTLESS Lighting!

To achieve dot-free evenly diffused lighting in Aluminum Profile "PH" choose from the following DOTLESS LED strips.
12V DOTLESS White LED Strip (Most Popular!)
24V DOTLESS White LED Strip

Best Used with the Following GlowbackLED Products

Extra Pair of Mounting Clips for Aluminum Profile PH
UL-Listed White LED Strips
RGB Color Changing LED Strips
RGBW Color Changing and White LED Strips
Dimmable and Nondimmable Power Supplies
Connectors